WHITESIDE UD2102 - Up/Down Cut Spiral Cove used for covering the DOMINO

used for covering the DOMINO D 8 mm joint fixture

66" Dust Port: 4" Overall Width (side-to-side): 84

giving you the ability to accommodate stock that is much shorter or thinner

Cutting material: TC XL4000

Thin kerf blades reduce waste in expensive materials and require less horsepower to operate

WHITESIDE UD2102 - Up/Down Cut Spiral Cove used for covering the DOMINOMade from solid carbide, each bit contains up cut and down cut flutes. This flute design creates a compression cut that prevents fraying and splintering. Compression spirals will save you time and money on finishing your projects edges by reducing sanding time. Materials: Natural woods, composites, hard plastics, thin aluminum Recommended RPM: 18,000 20,000 (max 24,000)