WHITESIDE 2310 - 45° Chamfer Bit Lock Compatible with the SYS-Combi 2

Compatible with the SYS-Combi 2

generating less chatter and a smoother cut

You must ramp down to a depth of 1/4" deep over a 20" run

mobile design with non-marking

and keeps your cutter edges sharp and clean through hours of cutting

WHITESIDE 2310 - 45° Chamfer Bit Lock Compatible with the SYS-Combi 2This chamfer bit is designed to cut a 45 degree angle on your work piece. Whether you are using the 45 as a decorative edge or making mitered corners, the two flute carbide tipped design will give you an accurate cut every time. Materials: Natural woods, composite woods, hard plastics Recommended RPM: 10,000 12,000 (max 12,000)